J.Hilburn Newsroom

Category: How To Measure

  • How To: Measure J.Hilburn Garments

    The below PDFs can be used as guides for how to measure J.Hilburn garments, by product type.

    Please reach out to Fit Advice at fitadvice@jhilburn.com or (214) 631-2601 with any questions.

  • How to Measure Custom Belts

    J.Hilburn Custom Belts are handcrafted in Texas one at a time, from fine Italian calf leather in a range of colors. The middle hole of the belt will fall at the ordered measurement with approximately 6″ of tail extending beyond the hole.  To measure the finished belt, start at the point where the buckle meets the leather, hold the tape measure flat and measure to the middle hole. This measurement will match the ordered belt size. Past the middle hole there will be an additional 6”-7″ of leather. For example a size 35 belt will measure 35” to the middle hole and 41” to the end of the leather.

  • Quality Control Data in Green Room

     

    If you have any questions concerning the way a garment was produced at the factory, you can use the quality control data available in your Green Room to confirm the specs of the garments you’ve ordered.

    This quality control information can be accessed by clicking “View Manufacturer Quality Data” on any shipped custom garment.

    The Quality Control window will display the Expected, Actual, and Variance measurements, as well as the Tolerance for each measurement.

    • Measurement- the area of the garment that is measured by the factory
    • Ordered – this will show how the garment was ordered
    • Expected- this measurement is the specification that the finished garment should measure
    • Actual- this is the finished measurement of the finished garment measured during the quality control inspection
    • Tolerance- Tolerance is the amount a measurement can be greater or less than the Expected measurement, and still be considered correct
    • Variance – variance is how far the actual measurement is from the expected measurement

    Check out these 4 easy steps!

    Step 1: Go to your Green Room

    Step 2: Open your client profile and go to the order section

    Step 3: Select “View Manufacturer Quality Data”

    Step 4: The data will pop up on your screen to display the below data details

    We believe that providing this insight to your Clients’ products can help you troubleshoot any possible fit issues that may arise. To better understand how the factory measure garments follow the link bellow. 

    https://newsroom.myjhilburn.com/how-to-measure-j-hilburn-garments/

     

     Please feel free to reach out to Fit Advice with any questions, we are here to help!